General Scanner Settings¶
To access scanner settings, go to the Scanner tab and click the Settings button on the left.
This setting enables or disables the discovery of resources in the scope and searches for typical vulnerabilities.
To manually restart the scanning, if the setting is on, switch it off, and then switch it back on again.
Viewing detected vulnerabilities
The vulnerabilities found by the scanner can be viewed on the Vulnerabilities tab of the web interface.
In the scanner settings, you can perform the following actions:
Configuring the list of detected vulnerabilities
Disabling and enabling vulnerability re-check
Configuring the scanner
To see detailed information about configuring the scanner, proceed to this link.
Active Threat Verification¶
This setting enables or completely disables automatic attack reproduction by the scanner.
You can later manually run the attack verification by clicking the Check button or using the Rules tab.
Scanner's RPS Limits¶
This setting limits the maximum load on the web application that will be generated by the scanner requests.
The maximum number of requests per second (RPS) can be configured
to a domain
to an IP address
If multiple domains are associated with the same IP address, then the speed of requests to this IP address will not exceed the limits for the IP address. If multiple IP addresses are associated with one domain, then the total speed of requests to these IP addresses within this domain will not exceed the limits for the domain.
Limits can be overridden for individual IP addresses or domains. This is done within the network scope section.
To restore default scanner RPS settings, click the Restore defaults button.
Click Save to apply any changes made to the scanner settings.